Breville Smart Crystal Luxe BKE855 Manuel D'instructions page 11

BEFORE FIRST USE
Remove and safely discard any packaging
material or promotional labels attached to your
kettle. It is recommended before first use to fill
the kettle to the maximum level with cold tap
water, bring to the boil by selecting the BOIL 212 °F
(100 °C) button, then discard the water. Your
kettle will only operate when positioned on the
power base. The kettle will automatically switch
off when the water has reached the selected
temperature.
OPERATION OF YOUR KETTLE
1.
To fill the kettle, remove it from the power base
and open lid by pressing the lid release button.
Fill with the desired amount of water.
NOTE
Always fill the kettle between the minimum
and maximum marks on the vessel. Too little
water will result in the kettle switching Off due
to the safety boil dry protection. Filling above
the maximum mark (MAX) may result in boiling
water splashing from the kettle.
2.
Ensure the lid is closed and locked firmly
into place. Position the kettle securely onto
the power base. Insert the power plug into a
120 power outlet and switch on. The START/
CANCEL and 212 °F (100 °C) BOIL button
LED lights will illuminate in white for 30 seconds.
A beep will sound for two seconds. All the
button LED lights will automatically switch off
after 30 seconds if not selected.
NOTE
If the START/CANCEL button is pressed (before
selecting a temperature button), the START /
CANCEL button surround will illuminate in red
and the 212 °F (100 °C) button surround will
illuminate and the kettle will start heating.
3.
Select the desired setting by pressing one
of the five temperature buttons (175°, 195°,
200°, 205°, 212°). The selected button and the
START/CANCEL button surround will illuminate
in white.
NOTE
The KEEP WARM function can be selected
before, during or on completion of the water
heating cycle.
4.
Press the START/CANCEL button and the
surround will illuminate in red, the selected
temperature button surround will illuminate and
the kettle will start heating. Do not remove the
kettle from the power base during operation.
Ensure the kettle has switched off after the
water has boiled or the selected temperature
has been reached before removing the kettle
from the power base. If the kettle is removed
from the power base during the KEEP WARM
function the kettle will automatically switch off.
5.
When the kettle has heated the water to the
selected temperature, a beep will sound, the
START/CANCEL button will change colour
from red to white and the selected temperature
button will remain illuminated for 30 seconds
before switching off.
6.
If the KEEP WARM function has been selected,
the KEEP WARM button surround will remain
illuminated in red, the selected temperature
button surround will remain illuminated in white,
and the kettle will maintain the desired setting
for 20 minutes.
7.
If further heating of the kettle is not required,
switch off at the power outlet, unplug the power
cord and empty the water from the kettle.
Replace the kettle onto the power base and
close the lid.
EN-US
11