Velleman CAMCOLVC24 Mode D'emploi page 10

Unplug the device from the USB port.
2.
®
Macintosh
In the Finder, click the Eject icon
1.
Unplug the device from the USB port.
2.
7. Waterproof Housing
The camera comes with a waterproof housing. It is recommended to test the
housing without the camera before use.
•
Before sealing the waterproof case, make sure the camera housing's
rubber seal is clean. A single hair or grain of sand can cause a leak. You
can test the housing by closing the case without inserting the camera.
Submerse the case completely in water for about a minute. Remove the
case from the water, dry off its exterior with a towel, then open the
case. If the entire interior is dry, the case is safe for use under water.
•
Remember to put the camera in the desired mode before inserting the
camera in the waterproof case. There is no external button to change
the camera mode.
•
After every use in salt water, you will need to rinse the outside of the
housing with non-salt water and dry it. Not doing this can eventually
cause corrosion of the hinge pin and salt build-up in the seal, which can
cause failure.
•
To clean the seal, rinse in fresh water and shake dry. Drying the seal
with a cloth may cause the seal to leak. Re-install the seal into the
grooves in the backdoor of the housing.
8. Cleaning and Maintenance
Battery
WARNING
•
•
•
There are no user-serviceable parts.
•
Wipe the device regularly with a dry, lint-free cloth. Do not use alcohol
or solvents.
V. 01 – 09/10/2014
Do not puncture or throw batteries in fire as they
might explode.
Keep batteries away from children.
CAMCOLVC24
next to the device.
This device contains an internal,
non-removable, rechargeable
battery. When the device is end-
of-life, it must be disposed of in
accordance with local
regulations.
10 ©Velleman nv