CARRARO Santerno 2200 TL Guide Rapide page 14

SUNWAY M XS
Crimp the cable in the connector insert module using the Lumberg crimp tool (LC4-CX CZK48) (the crimp tool is not
standard supplied).
•
Open the crimp tool (insert K)
•
Fit the insert module into the correct diameter (4.0 to 6.0) of the crimp tool and lock it with insert K
•
Close the crimp tool without tightening the insert module, then release insert K
•
Fit the stripped cable section into the insert module
•
Tighten the crimp tool completely
Fit the insert module into the connector.
12/30
DC CONNECTION
Cable
Type of Cable cross-
connector section
2
LC4-CP...4 4 mm (AWG12)
2
LC4-CP...6 6 mm (AWG10)
QUICK START GUIDE
Length
Outer
diameter
L
+1
6mm
6.3-7.8mm
+1
6mm