Renkforce 1301270 Notice D'emploi page 29

b) Mains connection
Please ensure that the device voltage specified on the product corresponds with the available
power supply before inserting the plug. Do not plug in the product if the rated voltage does not
comply with the on-site power supply.
Connecting the device to an incorrect supply voltage may result in serious damage and hazards
for the user.
The mains socket that the device is connected to must be easily accessible so that the device
may be disconnected from the power supply quickly and easily in case of error.
Turn the product off before connecting to or disconnecting from the power supply.
Make sure that the mains cable is not pinched or damaged by sharp edges. Lay the cable so that
no one may trip on or become entangled in it. This poses a risk of injury.
Take care when handling mains cables and mains sockets. Mains voltage can cause fatal
electric shocks.
Make sure that the mains cable is undamaged and does not run beneath the product or across
a hot or sharp location. The power cord may not hang over the edge of a table or be pinched.
Connect the power plug to an appropriate power outlet.
c) General notes on operation
• Use the product only when the ring (5), glass tray (1) and turntable support (6) are in their correct position.
Make sure that the glass tray can rotate freely.
• Place the container holding the food you wish to heat in the middle of the glass tray.
• Always make sure the door locks into place when closing the door.
• The product will start immediately after completing the time or weight setting.
• When the cooking process has finished, an acoustic signal will sound.
• Make sure the product is switched off when removing food from the cooking chamber. The rotary time/
weight control (4) must be at 0 position.
• When not using the product, the rotary time/weight control must be at 0 position.
• When defrosting food does not lead to satisfactory results, increase the time or choose a higher weight
setting respectively.
29