Meec tools 013148 Mode D'emploi page 10

EN
SAFETY INSTRUCTIONS
• If the product is not correctly calibrated
there is a risk of damaging the product,
parts and/or fasteners.
• The product must be calibrated regularly
to ensure it is completely accurate.
• Do not exceed the set torque, this can
result in a risk of damaging the product
and/or parts.
• Do not use the product to remove
jammed fasteners.
• Do not use an extension on the handle to
increase the torque. Risk of personal injury
if the product breaks or slips.
• Never lubricate the inner mechanism on
the product.
• Do not immerse the product in water or
any other liquid.
• Do not attempt to set a lower torque than
the lowest marked setting.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
TECHNICAL DATA
Measuring range
Socket
DESCRIPTION
Torque wrench with ratchet and 3/8" square
drive. The wrench is reversible and controlled
tightening takes place by means of a click
system that triggers a tactile and audio
prompt to counteract overtightening.
10
The measurement range is 20–110 Nm with an
accuracy of ±4%. Excellent tool for the repair
and maintenance of vehicles as the bolts can
be set with high precision.
1.
2.
3.
4.
5.
6.
20 – 110 Nm
3/8"
•
•
•
USE
Release the adjuster mechanism by
undoing the locking screws.
FIG. 1
Turn the handle clockwise to increase,
or anticlockwise to reduce the set torque.
The product has two scales. The set torque
consists of the sum of the settings on both
scales. For example to set 56 Nm, turn the
handle until the edge of the adjuster ring
is at the line for 50 and the line for 0 is in
lie with the vertical line.
FIG. 2
The set torque is then 50 Nm. Turn the
adjuster ring until the line for 6 is in line
with the vertical line.
FIG. 3
Tighten the locking screws when the
required torque has been set.
When tightening fasteners, hold the
handle and tighten in the required
direction until it clicks and you feel a jolt.
FIG. 4
MAINTENANCE
Clean product with a soft cloth. Do not
use detergent that can affect the lubricant
in the product.
Store the product in its case, set to the
lowest torque to relieve the spring.
The internal spring in the product must be
tensioned to retain precision. To tension
the spring, lock the product head in a vice
or with an attached fastener and move