Table des Matières
Publicité
installation
1
Vanity and vanity base cabinet
installation
(Vanity shown as example):
(If applicable):
Remove product components from carton and set on
soft, clean surface. Place unit onto its top to gain access
to the bottom. Position leg into place and insert bolts
(included) through corner brace.
Place shelf onto 4 legs and align holes. Screw 4 feet
into place through the shelf and into the legs. After all
legs and feet are tight, rotate unit onto its legs.
instalación
installation
Place your vanity base cabinet into the desired position.
Drill through cabinet back braces into pre-located wall
studs using a 3/32in. diameter drill bit. Holes should
come no closer than 2 inches from any inside edge.
Insert the installation screws into the holes and tighten
securely.
6
Publicité
Table des Matières
