Candy AQUA 1042DE/2-S Mode D'emploi page 55

OPTION BUTTONS indicator lights
These light up when the relevant buttons
are pressed.
If an option is selected that is not
compatible with
programme then the option indicator
light first flashes and then goes off.
PROGRAMME START indicator light
This lights up when the START/PAUSE
button has been pressed.
Digital Display
The display's indicator system allows you to
be constantly informed about the status of
the machine.
1
1) CYCLE DURATION
l
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
l
During the initial filling phase of the cycle
the machine calculates the actual cycle
time needed based on the load size,
content and options selected. The real
time of the wash will then be displayed.
This time can recaulculate during the
wash depending on detergent levels and
load balancing.
the selected
2 3
4
2) DOOR LOCKED INDICATOR LIGHT
l
The indicator light is illuminated when the
door is fully closed.
Close the door BEFORE selecting the
START/PAUSE button.
l
When START/PAUSE is pressed on the
machine with the door closed, the
indicator will flash momentarily and then
illuminate.
If the door is not properly closed,
the light will continue to flash for
about 7 seconds, after which the
start command will be automatically
cancelled. In this case, close the
door in the proper way and press
the START/PAUSE button.
l
A special safety device prevents the door
from being opened immediately after the
end of the cycle. Wait for 2 minutes after
the wash cycle has finished and the
DOOR LOCKED light has gone out before
opening the door. At the end of the cycle
turn the programme selector to OFF.
3) SPIN SPEED
This show the spin speed of the selected
programme that can be changed or omitted
by the relevant button.
4) DELAY START INDICATOR LIGHT
This flashes when delay start has been set.
55