Candy AQUA 1042DE/2-S Mode D'emploi page 47

Setting
The washing machine should be
l
installed in its final position such
that the water fill hose is not
kinked or trapped. The corrugated
drain hose should be inserted into
suitable drain pipe of between 50
cm and 85 cm height above the
floor using the curved drain hose
support. If an under sink connection
is used the drain hose must be
routed above the sink overfill opening
to prevent back siphoning. Care
must be taken to avoid kinking or
trapping the drain hose (fig. 8).
Level the appliance using the
l
feet as illustrated in fig. 9:
a. turn the nut clockwise to
release the screw;
b. rotate the foot to raise or lower it
until it touches to the floor;
c. lock the foot, screwing in the
nut, until it tightens against to the
bottom of the washing machine.
Plug in the appliance.
l
WARNING:
Contact the Customer Service
Centre should the power cord
need replacement.
Installation faults
covered by the manufacturers
warranty.
8
*
ACCESSORY SOLD SEPARATELY
9
are not
47
min 4 cm
2,5 mt
max
min 50 cm
max 85 cm
A
B
C