Dolmar PT-1900 Instructions De Montage page 7

14
16
E
8
F
1
2
G
15
17
7
6
5
4
2
1 3
5
Mount the clamp bracket (14) from underneath (see circled
diagram) against the support plate (17) using screws (16).
Fit nuts (15) and tighten firmly.
Mounting the guide wheel
Push screw (1) through the rectangular hole on the guide trol-
ley (2) (align the sides of the screw with the sides of the hole).
Mount guide wheel (3), compression washer (4), washer (5)
and nut (6).
Tighten nut (6) so that the guide wheel can be turned on the
guide trolley.
Push second screw (8) through the long hole on the guide
trolley and the hole on the guide wheel.
Tighten quick-action lever (7).
NOTE:
Pulling the quick-action lever cancels out the screw effect. It
can be tightened up by pulling the lever again.
Mounting the water tank
Unscrew the star handle (1) and remove control shaft (2).
Mount tank holder (3) and control shaft (2) with star handle
(see picture).
Put the water tank (4) in the tank holder (3).
When the Power Cut is assembled the hose (6) will go along
the side of the Power Cut and attach to the water set coupling.
NOTE:
Adjust the tank holder (3) so that the water tank is flush with
4
the guide trolley when working.
NOTE:
Before filling the water tank, detach the hose (6) from the water
set coupling and take the water tank out of the tank holder,
3 unscrew cap (5) and fill with clean water. Do not allow dirt to
get into the tank, as it could block the sprinkler nozzles.
6
7