Connection Of The Device - Goobay 67178 Mode D'emploi

6.1

Connection of the device

•
•
Multiswitch
13 V / 0 kHz
18 V / 0 kHz
13 V / 22 kHz
18 V / 22 kHz
Tab. 3: Device connection
•
TV and radio reception via a terrestrial antenna:
•
There are 2 possibilities for further connections:
1.
2.
Use high-quality F connector coaxial cable with at least
90 dB shielding.
Connect the LNB connections of the multiswitch (3, 4, 6, 7)
with the LNB outputs of the satellite dish as shown in the
following table:
Quattro-LNB
LNC A Vertical / Low
LNC B Horizontal / Low
LNC C Vertical / High
LNC D Horizontal / High
Connect the outputs of the multiswitch (1, 8) with the cables
that lead to the individual receiver antenna sockets.
(See Fig. 4)
Connect the antenna output with the input marked
„TER" on the multiswitch (5) for the terrestrial antenna.
Either via a satellite-enabled antenna socket to receiver.
The input also enables power supply of the antenna
preamplifier for current up to 100mA. The
preamplifier is automatically disconnected from mains
voltage by an internal fuse when consumes more than
100 mA.
Or connect the multiswitch directly to a receiver.
Quad-LNB
any
any
any, need 22 kHz generator
any, need 22 kHz generator
17