Krups Espresseria Automatic EA81 Serie Mode D'emploi page 23

4. Info (number of cycles)
The light comes on.
To go to the next stage, press the
To leave settings mode, press
At any of these stages, you can leave settings mode by pressing the
of the lights will go off. These settings stay applicable even if there is an electric power cut. You can change these settings
at any time by repeating these operations.
TROUBLESHOOTING, CORRECTIVE ACTIONS
PROBLEM MALFUNCTION
Your appliance detects a fault.
The appliance does not turn on when the
pressed.
The coffee grinder makes a strange noise.
The steam nozzle makes a noise.
The steam nozzle on your appliance seems partially or
completely clogged.
The steam nozzle makes little or no milk froth.
No steam comes out of the nozzle.
The auto-cappuccino set makes little or no froth.
The auto-cappuccino set does not take in milk.
There is water underneath the appliance.
After emptying the coffee grounds collector, the warning
message is still displayed on the screen.
22
button. You will go back to adjustment 1.
.
button is
button if you have finished your adjustments. All
CORRECTIVE ACTION
Switch off and disconnect the appliance, remove the fil-
ter cartridge, wait for a minute and restart the appliance.
Check your fuses and plug sockets.
Check that the two power plugs are correctly pushed in
the socket.
There is a foreign body in the grinder. Disconnect the
appliance before investigating. See if you can extract
the foreign body using your vacuum cleaner.
Check that the steam nozzle is correctly attached to its
corresponding end piece.
Ensure that the opening in the end piece is not ob-
structed by milk residue or limescale. Unclog the holes
with the needle supplied with your appliance.
For milk-based drinks, use very fresh, very cold pas-
teurised or UHT milk. It is also advisable to use a cold
container. If the results do not improve, try changing the
brand of milk.
Empty the tank and temporarily remove the filter car-
tridge. Fill the water tank with mineral water which is
high in calcium (> 100 mg/l) and run successive steam
cycles.
Check that the accessory is correctly attached to the
appliance, remove it then replace it.
Check that the flexible tube is not obstructed or pierced
and that it is correctly attached to the accessory so as
to make it airtight. Rinse and clean the accessory (refer
to the "Auto-cappuccino accessory" chapter).
Before removing the water tank, wait for 15 seconds
after the coffee has finished flowing so that the appli-
ance finishes its cycle properly.
Check that the drip tray is correctly positioned on the
appliance; it should always be in place, even when the
appliance is not in use.
Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
Clean the tank and its connection regularly to avoid the
build up of scale, which can cause leaks.
Remove the coffee grounds collector and ensure it is
empty and clean. Wait at least 6 seconds before replac-
ing, and ensure it is correctly installed.