König KN-WS400N Mode D'emploi page 3

3.2 Normal states
1. Hold "Set" for 2 seconds to enter into time setting.
2. Click "Alarm" to switch the alarm on/off.
3. Hold "Alarm" for 2 seconds to enter into Alarm setting.
4. Click "Up" to switch between 12 hr/24 hr.
5. Press "Down" to switch between °C/°F.
6. When ALARM rings, click "snooze" to enter into the snooze state every 5 minutes.
7. Press "Channel" to switch RF channel, CH1  CH2  CH3.
8. Hold "Channel" key for 2 seconds to clear out all data of current "Channel".
3.3 Time set
1. Hold "Set" key for 2 seconds to enter into time setting.
2. The sequence of time setting: Year  Month  Date  Language  Hour 
Minute  Time zone  Exit.
3. There will have 1 Hz flashing during setting.
4. Press "Set" to confirm the setting, and enter the next setting state.
5. Press "Up" one time, the setting will go ahead for one step; hold the key for 2
seconds, it will run forward by 8 steps/second.
6. Press "Down" one time, the setting will backward for one step; hold for 2 seconds,
it will run back by 8 steps/second.
7. Moon phase is changed accordingly.
8. The system will exit automatically if no key is operated in 8 seconds.
3.4 Alarm set
1. Hold "Alarm" key for 2 second to enter into alarm setting.
2. The sequence of alarm setting: Hour  Minute  exit.
3. There will have 1 Hz flashing during setting.
4. Press "Alarm" to confirm the setting, and enter the next setting state.
5. Press "Up" one time, the setting will go ahead for one step; hold the keys for 2
seconds, it will run forward by 8 steps/seconds.
6. Press "Down" one time, the setting will backward for one step; hold for 2 seconds,
it will run back by 8 steps/second.
7. The system will exit automatically if no key is operated in 8 seconds.
4. Function and Effect
4.1 The receiving function of RF
1. After installing the battery and checking temperature/humidity, it will enter RF
receiving state automatically for 3 minutes.
2. Under normal display mode, hold the "Channel" key for 2 seconds to clear out the
channel information.
3. If there is no effective signal with same ID code received for the current channel
in 35 minutes, the temperature of that CH will show "----".
3
ENGLISH