Peavey PV 8 USB Mode D'emploi page 11

Front Panel
Stereo (1⁄4") Inputs
27
These 1⁄4" unbalanced inputs work as a stereo line input using both jacks or as a mono input if the
connection is made to the Left/Mono input only. The A/B input selector must be in the "A" position for
these jacks to be active.
RCA Inputs
28
These RCA inputs work as stereo line inputs. The A/B input selector must be in the "B" position for
these jacks to be active.
A/B Switch
29
The A/B input selector switch expands the capability of the PV®8 mixer by allowing two stereo sources
to be connected to each stereo line input. Instead of re-patching, the switch selects which input jacks
are active.
EFX Return
30
The EFX Return inputs (Left/Mono‚ Right) feature two 1⁄4" TS jacks. These inputs can be used with Tip‚
Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors. The EFX Return is controlled via
the EFX/Return Level Control (19).
Left/Right Outputs
31
The Left/Right Outputs feature two 1⁄4" TRS Z-balanced jacks. These outputs can be used with Tip‚ Ring,
Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors.
Control Room Outputs
32
The Control Room Outputs feature two 1⁄4" TRS Z-balanced jacks. These outputs can be used with Tip,
Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors. The Control Room Output Level
is adjusted with the Headphone Level Control (21).
MON Send
33
The MON Send features a 1⁄4" TRS Z-balanced jack in the master section. This output can be used with
the Tip, Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors. The MON mix is deter-
mined by the amount of signal being sent to the MON bus in each channel and by the Monitor master
control.
EFX Send
34
The EFX Send features a 1⁄4" TRS Z-balanced jack in the master section. These outputs can be used with
Tip‚ Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors. The EFX mix is determined
by the amount of signal being sent to the EFX bus in each channel and by the EFX Master Control.
11