Publicité
Les langues disponibles
Les langues disponibles
(e) Push control knob (U) onto valve control stem.
See Fig.20.
(f) Plug ignition wire into igniter wire hanging from
electrode on underside of burner. See Fig.21.
7. Igniter and Battery Assembly
(a) Remove igniter cover and lock washer from
igniter. Insert igniter through from back of side
burner control panel, secure lock washer from
front of side burner control panel. See Fig.22.
(b) Install battery (V) into ignition box with positive
terminal facing outward.
(c) Replace the ignition battery cap after the
battery has been installed. See Fig.22.
Note: Make sure the igniter assembled
with the wires upward in order that the
wires are away from manifold enough.
See illustration below:
igniter
manifold
Fig.20
U
Fig.21
Fig.22
v
16
Lock Washer
Publicité
