Palram Skylight Shed Mode D'emploi page 3

IMPORTANT
Please read
these instructions carefully before you start to assemble this shed.
Please carry
out the
steps
in
the order set
out
in
these instructions.
Keep these
instructions
in
a
safe place
for future
reference.
Tools &
Equipment
Tool
-
(supplied)
Safety
V
This shed
must
be
placed and fixed on
a
leveled surface to ensure
its
stability.
Make sure that screws and anchors are compatible with surface type.
Some parts have metal edges. Please be careful
when handling components.
Always wear gloves, eye
protection, and long sleeves when assembling or
performing any maintenance on your
shed.
Do
not attempt assembly
on days
with
strong winds or low temperatures. If using
a
stepladder or power tools ensure
that
you
follow
the manufacturer's safety advice.
If using
a
stepladder or power tools ensure
that
you
follow
the manufacturer's
safety advice.
Do not stand on the roof.
Do
not
store
hot items
such as
recently
used grills,
blowtorches
etc. in
the
shed.
Heavy or sharp
articles should not
be
leaned against the wall panels.
To
prevent suffocation,
do
not allow children to
play
with
packing materials.
Shed
must
be secured by
drilling through floor panels holes locations and inserting
suitable screws into ground
Betore you start
IRConsult
your
local
authorities for
any
building limitations
or
permits required to
construct this garden
shed.
IRComplete site
preparation before unpacking parts and beginning assembly.
IRIt
is
highly recommended to
be
assisted by
a
second person
in
some steps.
IRSort
the parts and check against the contents parts list.
IRPlease
take safety precautions during assembly.
During Assembly
N
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates
that the installer should
be
inside the product.
Attention:
ni
This icon indicates that
the installer should
be
outside the product.
RtWhen
assembling the roof, it
is
important
to drill the screws at the
top
end
of the panel and to
make sure
that
screws
penetrate through
in
order to achieve maximum durability.
V
Make sure
to position the
panel's
bottom end towards the shed floor
and
that
it
is
enclosing it.
Step
3: Place
the first wall panel at the back of the
shed,
according to the stamped
serial
number (part 7699).
Step 28:
Please
apply silicone (caulk) sealant at the connection between both
Aluminum
profiles
(diagram
b),
in
order to prevent water from seeping
in.
Step 39: Note
that
panels and profiles are connected
in
the right direction and
that profile
holes are placed
correctly
as
illustrated.
Step 41:
Push
aluminum profiles against part #8439 and then
use
Self-Drilling
screws
(#4045) to connect to the profile (diagram b).
No pre holes
is
needed.
Step 46: Anchor the shed on
to
a
solid surface such
as
concrete or asphalt; use
suitable
screws
and plugs.
(Screws and plugs are
not supplied).
*Please
note: Anchoring this product to the ground
is
essential to
its
stability
and
rigidity.
It
is
required to complete this stage
in
order for your warranty to
be
valid.
o no ig en screws an nu
s
(411 & 412) un
i
completion
o
assembly process.
These
2
icons indi
crews'tightening
is
required or not.
A
c.0s411
1
*
II
1
r(IIVAID