Publicité
Les langues disponibles
Les langues disponibles
Installing Adapter Brackets to Display
NOTE: If display has a VESA 400 horizontal
mounting pattern, skip to step 2-3 or 2-4 on page 9.
NOTE: For VESA 200x200 or VESA 200x100
mount hole patterns, skip to step 3 on page 10.
NOTE: For dedicated PLP plate installation skip to
step 4 on page 12.
Remove four 1/4-20 x .6" screws using 5mm allen
2
wrench (I) and loosen two 1/4-20 x 1.25" screws
1/2 turn to allow for display bracket adjustment.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
2-1
Place display face side down and refer to display manufacturers instructions for removing obstructions from the
back of the display. Adjust display brackets to align with display mounting holes.
Measure horizontal mounting hole pattern and choose fi xed stop-position from chart below.
horizontal mounting hole pattern
10-3/4" - 16-1/16" (273 - 408 mm)
15-1/16" - 21-9/16" (383 - 548 mm)
20-7/16" - 27-9/16" (519 - 700 mm)
fixed stop-position
#1
#2
#3
FIXED STOP-POSTION #1
7 of 58
1/4-20 x .6" SCREWS
FIXED STOP-POSTION #3
FIXED STOP-POSTION #2
ISSUED: 10-30-09 SHEET #: 095-9297-7 07-11-11
1/4-20 x 1.25" SCREWS
Publicité
