Magnat MA 900 Mode D'emploi/Certificat De Garantie page 13

OPERATIONAL ELEMENTS AND CONNECTIONS – FRONT PANEL
1 2
1 LED STATUS INDICATION
This illuminated display indicates the MA 900's
2 possible states:
• LED is illuminated green: The MA 900 is
switched on. The device is ready for use.
• LED is illuminated red: The MA 900 is in the
standby mode.
2 ON/STBY
Switches the device on when it is in the standby
mode. If the LED does not illuminate, actuate
the power switch located on the rear of the
device. Conversely the device can be switched
from power operation to the standby mode.
3 HEADPHONES
6.3 mm stereo output jack for headphones.
The speakers are deactivated when this jack is
used. Set the volume to a low level before con-
necting headphones.
15 14
3 4 5 6
3 LINE IN
3.5 mm stereo input jack for an auxiliary audio
device (e.g. MP3 player, etc.).
5 MONO
Switches between Stereo and Mono.
A long press opens the "SOURCE GAIN and
SOURCE RENAME" menu.
6 SOURCE (INPUT SELECTOR SWITCH)
Switches between the different audio sources:
• PHONO MM: Record players with a Moving
Magnet System (MM) or MC system with high
output level (high output MC).
• PHONO MC: Record players with Moving Coil
System (MC).
• CD: CD player.
• STREAMER or DVD
• AUX: Other audio devices.
• TAPE: Tape or cassette recorder.
13
7 8
• LINE IN: Front input for portable devices
• TUNER: Selection of the FM tuner
• DIGITAL OPT 1/2, DIGITAL COAX 1/2:
Connecting to digital audio sources.
• BT: Connection to a Bluetooth device
7 BALANCE
For adjusting the stereo balance between the
speakers to the right or to the left.
8, 9, 10 EQUALISATION: BASS / MID /
TREBLE
The bass, mid-range and treble reproduction
can be set individually with these controls.
11 DIRECT
The device is switched to the linear mode.
The TREBLE, MID and BASS levels cannot be
adjusted in this mode. DIRECT ON appears in
the display.
13
12 11
9 10
12 SENSOR FOR THE REMOTE CONTROL
Please aim at this sensor when using the remo-
te control.
13 VOLUME
For adjusting the overall volume of the music.
14 DIM
This button can be used to adjust the brightness
of the display (3 levels).
15 DISPLAY
The following information is indicated in the
display:
• Heating phase of the tube.
This lasts for around 30 seconds after the
device has been switched on.
• Selected audio input
• Volume information