Publicité
Les langues disponibles
Les langues disponibles
FILTERS
Filter
Pre-filter
Active carbon filter
HEPA filter
NanoCaptur filter
This data is based on an average use of 8 hours per day at speed 2.
The recommended frequency for cleaning and replacing the filters may vary depending on the duration
of use and the operating environment.
• A "HEPA" light indicates when the HEPA filter needs to be replaced.
The 'Odor' light indicates when the carbon filter needs to be replaced.
• The NanoCaptur filter contains translucent granules which change color according to the formaldehyde
absorption rate. Refer to the color chart on the inside of the panel or the filter itself to establish the filter
saturation rate.Once the saturation rate has reached its maximum, the filter must be replaced. You have
to check the filter saturation rate every six months.
• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.
CAUTION:
• The appliance's efficiency can be reduced if the pre-filter is not cleaned regularly.
• Never use a pre-filter that is still damp.
•
The pre-filter is the only filter which can be re-used and washed with water. The HEPA,
NanoCaptur and active carbon filters cannot be cleaned and re-used. Never wash with water.
• To replace the filters, follow the instructions in the section « Disassembling/Reassembling filters ».
Your replacement filters are available under the following codes:
Filtre
HEPA filter
Active carbon filter
NanoCaptur filter
IMPORTANT: Resetting the filters
The reset light flashes when a filter needs to be replaced. Once the filter has been replaced, hold
down the reset button for 2 seconds.
Forced reset:
If you have replaced a filter before its end of life, force the reset of the filter replacement cycle:
1. Hold the reset button for 2 seconds.
2. Press the reset button briefly to select the filter you have changed.
3. After selecting the filter to reset, hold the reset button for 2 seconds. The electronic meter is then
reset.
4. If no button is activated for 10 seconds in forced reset mode, the reset mode is canceled.
« TIPS FOR CHANGING FILTERS »
• Avoid handling used filters if you suffer from allergies or asthma.
• Wear gloves when changing the filters, or wash your hands well afterwards.
• Put used filters directly into a closed, air-tight bag before throwing them away
to avoid spreading pollutants.
8
Action
Clean
Replace
Replace
Replace
Code PU4010
XD6070
XD6060
XD6080
.
.
Cycles
Every 2 to 4 weeks
Every 12 months
Every 3 years
Color changing
(see Color chart on filter)
Code PU6010
XD6071
XD6061
XD6081
Publicité
