Amplicomms TV 200 Mode D'emploi page 16

Note:
- The LED indicator on the receiver will blink slowly red with "Beep"
sound in every minute when the battery level is low. Recharge the batte-
ry. Always ensure that the Headphone Receiver is switched to OFF positi-
on while the batteries are charging.
Communication via the built-in microphone
The microphone opening at the front of the receiver pick up the sounds of
your surroundings. When the microphone is switched on, you will hear
your surroundings louder. You can hear for example your door bell, your
telephone or your conversational partner even when you are wearing the
receiver.
Press the button to switch the microphone on. The
power on indicator will turn from green to red. Make
sure that the microphone opening is not covered!
You can hear your surroundings and you use the
receiver as an assistive listening device which helps
you to better hear other people.
To switch the microphone off press the button again. The power on indica-
tor will turn to green and you will hear the sound from the audio source.
Tone adjustment
When necessary, treble or bass can be adjusted by the tone clarity button
on the receiver. Simply press the tone button to select the desired needs:
- 1 short beep - Treble Boost
- 2 short beeps - Bass Boost
- long beep - Flat
TV 200
13