Publicité
Les langues disponibles
Les langues disponibles
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Blower
Blower Tube
Speed Tip
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this blower. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
ASSEMBLY
This product is intended for blower use only and is not
designed for vacuum use. Do not attempt to remove the
main reducer housing that covers the impellers. Removal
of the main reducer housing will expose the moving
impellers and contact with these impeller blades can
result in serious personal injury.
INSTALLING THE BLOWER TUBE
See Figures 2 - 3.
With the tab facing down, slide the blower tube over the
outlet on the blower housing.
Push the blower tube on the blower housing outlet until
the tab locks into place through the notch in the blower
housing.
To remove the tube, depress the tab and slide tube off.
To install the speed tip: Align the tab on the speed tip
with the notch on the blower tube and press together
until the tab locks into place.
To remove the speed tip: depress the tab and slide the
speed tip off.
NOTE: When the speed tip is installed the unit can generate
air speeds of 160 mph. To reduce air velocity and increase air
volume, cut the speed tip along one of the cut lines. Cut the
line closest to the end of the nozzle for a smaller increase in air
volume and the line farthest from the end for a greater increase
in air volume. Cut portions of the tube cannot be reassembled.
NOTICE:
When correctly assembled, the tube is difficult to sepa-
rate. If it can easily be pulled apart, the tube is not locked.
Check that the tab is aligned, and push the blower tube
on to the blower housing until the tube snaps into the
locked position. If the tube is not in the locked position,
it can separate during blower operation.
OPERATION
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
6 — English
WARNING:
WARNING:
Publicité
