Operation - Medisana WL 450 Mode D'emploi

Masquer les pouces Voir aussi pour WL 450:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
The packaging can be reused or recycled. Please dispose properly of any
packaging material no longer required. If you notice any transport damage
during unpacking, please contact your dealer without delay.
Please ensure that the polythene packing is kept away from the
reach of children! Risk of suffocation!

3 Operation

3.1
1.
Place the device on a solid and flat surface for use to ensure that it
cannot tip over or fall down.
Positioning
2.
Position the device about 40 - 50 cm away from your head, for exam-
and setup
ple on a bedside table.
3.
Plug the cable antenna to the the connector for cable antenna
the rear side of the device.
4.
Plug the mains cable end to the connector for power cable
rear side of the device and the power adapter to the wall outlet.
3.2
Press and hold the Set-button
in the display flashes. Adjust the time with the
Setting the
Press the Set-button
time and the
select one of two alarm settings (AL1 or AL2) or the Zizz (short time
alarms
alarm) for adjustment with the
The adjustment needs to be done in the same way with the
and
select the way of alarming: By radio (FM) or by nature sounds (Sound).
Depending on your selection you then need to adjust either the radio
frequency or one of the eight nature sounds. In the following you need to
set the volume and the light brightness level. If you only want to use the
light or sound/radio function, adjust the other function to 0.
If you do not press a button for at least 10 seconds, the device will quit
the setting mode automatically. To activate an alarm you need to press
the corresponding button (see 3.5 Activate an alarm resp. 3.6 Short time
alarm). In case an alarm is activated, the L-Mode-
buttons are not available.
3.3
With the S-Mode-button
press on the button you change the source in this sequence: SOUND
Choose the
(nature sounds) - FM (radio) - MPS (MP3 player) - OFF. If you have
source of
chosen the nature sounds, you additionally need to select one of the eight
sound
sounds with the
(S-Mode)
MP3 player with 3.5mm jack plug needs to be connected to the connector
for MP3 player
trolled with the buttons
2 Useful Information / 3 Operation
WARNING
again to confirm the time. After that, you may
buttons as for the time adjustment. Additionally you need to
and
and needs to be switched on. The volume can be con-
for about 3 seconds, until the time
,
and
you can choose a sound source. With each
buttons. For listening to MP3 music, a
and
.
on the
and
buttons.
buttons.
► ◄
,
and S-Mode-
GB
G
G
G
on
G
G
g
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

45105

Table des Matières