Tripp-Lite BC Personal Datashield BCPERS300 Manuel Du Propriétaire page 4

Basic Operation
On/OFF switch
With the UPS plugged in and equipment connected, place this switch in the ON
OFF On
position to enable battery backup. When the switch is placed in the OFF position, the
UPS battery will recharge and AC power will be present at the UPS outlets, but the
UPS will NOT provide battery backup power to connected equipment in the event of
a blackout or severe brownout.
indicator Lights
All Indicator Light descriptions apply when the UPS is plugged into an AC outlet and turned on.
LINE POWER: This green light will illuminate whenever the UPS is ON and
receiving normal AC line power.
BATTERY POWER: This red light will illuminate when the UPS is providing
equipment with battery power.
Other UPs Features
AC Receptacles: "UPS/Surge" receptacles are used to provide connected
equipment with AC line power during normal operation and battery power
during blackouts and brownouts. They also protect equipment against
damaging surges and line noise.
Battery Replacement Door: Under normal conditions, the original
battery in the UPS will last several years. Battery replacement should be
performed only by qualified service personnel. Refer to "Battery Warnings"
in the Safety section. Should the UPS require battery replacement, visit
Tripp Lite on the Web at www.tripplite.com/support/ battery/index.cfm to
locate the specific replacement battery for the UPS.
4