Philips PerfectCare PSG7028 Mode D'emploi page 8

English
10
Problem
The ironing board cover
becomes wet, or there are
water droplets on the floor/
garment.
The surface under the base of
the appliance becomes wet, or
steam and/or water comes out
from under the EASY DECALC
knob.
The iron does not heat up
and the amber DECALC light
flashes.
Warranty and support
If you need information or support, please visit www.philips.com/support or read the international warranty leaflet.
Cause
Your board cover is not designed to cope
with the high steam rate.
The EASY DECALC knob is not tightened
properly.
The rubber sealing ring of the EASY
DECALC knob is worn.
The appliance reminds you to perform the
descaling procedure. The light flashes after
approximately one month of use.
Solution
Use a layer of felt material in the board
cover to prevent water droplets.
Switch off the appliance and wait 2
hours for it to cool down. Unscrew and
reattach the knob to make sure it is
tightened.
Contact an authorized Philips service
center for a new EASY DECALC knob.
Perform the descaling procedure,
following the instructions in section
'Descaling the appliance'.