Zephyr MWD2401AS Guide D'utilisation, D'entretien Et D'installation page 18

Installation Instructions
Flush Mount Installation
2. Place the microwave drawer adjacent to the wall or cabinet. Plug the power supply cord into
the electrical outlet. The power supply cord can also be installed using an electrical outlet in an
adjacent cabinet.
3. Loop (do not tie) a 36" string around the power supply cord before the drawer is slid into place.
This string will keep the cord from falling behind the drawer.
4. Lift the microwave drawer into the cabinet cutout using the opening as grip. Carefully guide the
microwave drawer into the prepared opening.
5. As the microwave drawer is slid back, pull the string so the cord will lie on top of the drawer in a
natural loop and avoid pinching the cord between the drawer and the wall.
6. Once the cord is out the of way, slide the drawer 3/4 way back into the opening. Remove the
string by pulling on one end of the loop.
7. Slide the microwave drawer all the way back until the mounting flanges is flush with the face of
the cabinet
8. Open the microwave drawer. Use the 4 holes on the microwave drawer to guide in pre-drilling the
cabinet using a 1/16" drill bit. Refer to image on page 16.
9. Secure the drawer with (4) M4*16-F Philip countersunk screws.
Grounding Instructions
This appliance must be grounded. The microwave drawer is equipped with a cord having a grounding
wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and
grounded in accordance with the National Electrical Code and local codes and oridinances. In the
event of an electrical short circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current.
Improper use of the grounding plug can result in risks of electric
18
WARNING
shocks.
MWD2401AS Use, Care, and Installation Guide
B U I LT- I N
M I C R O WAV E
D R AW E R