Rf-t V MAN EVO FDCU Mode D'emploi page 11

V MAN EVO FDCU
m
ounting
Dismantling of the magnet and the contacts
1. Unlock the mechanism.
6. Remove the protection
cover.
Mounting of the magnet and the contacts
8. Mount the new module on
the positioning pins.
When using a VM magnet,
remove the blocking pin.
9. Mount the protection
cover to the mechanism.
If the mechanism is manipulated in any other way than described in this manual, Rf-Technologies will
decline any responsibility and the guarantee will immediately expire!
Magnet and FDCU for MAN EVO
2. Loosen the cover, then remove it.
3. Disconnect all electric wires and
remove the FDCB circuit board (if
present).
7. Remove the old magnet
module
10. Place the new circuit
board.
11. Fix the circuit board with
the spacers.
4. Remove the spacers.
5. Remove the current FDCU circuit
board.
12. Connect the mechanism
according to wiring diagram
and mount the cable glands.
13. Mount the cover.
K112-D
07/2013
14. Test the good functioning
of the mechanism.
15. Attach the label 'KIT'
and fill in the necessary
information.
11