Rf-t V MAN EVO FDCU Mode D'emploi page 10

V MAN EVO FDCU
a mano evo / manF evo
PPLications
CR2 + MANO
fig.
CA2 + MANO
fig.
o mano evo / manF evo
Peration
MANO EVO / MANF EVO
Manual rearmation:
Turn 90° with a Torcq key 13 mm (1)
Caution: An electromagnet (VM) needs power supply for
rearmation.
Motorized unlocking:
1. Switch off the power supply for at least 10 sec.
2. Power the actuator for at least 30sec. (respect the
prescribed voltage).
3. The rearmation stops automatically when detecting a
torque > 20 Nm
! Switch off the power supply after rearmation
! Switch off the power supply for at least 15 sec. in
between each rearmation cycle.
Manual unlocking:
Use the unlocking button (2)
Remote controlled unlocking:
By sending an electrical impulse (VD) or by interrupting
the power supply (VM) to the magnet.
Automatic unlocking (only for MANO EVO):
When the fusible link melts at 72°C
Magnet and FDCU for MAN EVO
CU4 + MANO
fig.
VU120 + MANF
fig.
CU2-15 + MANO
fig.
K112-D
07/2013
CU2 + MANO
fig.
1
2
Fig. MANO EVO
1
2
Fig. MANF EVO
10