Operation - Ryobi P3320 Manuel D'utilisation

WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General ventilation of most household spaces
This product will accept Ryobi One+ 18 V lithium-ion battery
packs and Ryobi One+ 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator's
Manuals for your Ryobi One+ battery pack and charger
models.
NOTICE:
This product is designed to be powered by either a Ryobi
One+ 18V battery pack (DC mode) or by electric power
(AC mode). Either power source can be used by installing
an approved battery pack or power cord into the product
as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 10.
 Place the power switch in the center, or OFF ( O ) position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.

OPERATION

NOTE: The battery pack should be recharged after
approximately 5 hours of use to reduce the possibility of
damage. Repeated deep discharge of the battery may
decrease storage capacity and battery life.
INSTALLING/REMOVING POWER CORD
See Figure 3, page 10.
 Place the power switch in the center, or OFF ( O ) position.
 Route the power cord through the cord retainer.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
STARTING/STOPPING THE PORTABLE FAN
See Figure 4, page 10.
 Connect the portable fan to an AC or DC power supply.
 To start the portable fan, move the power switch to the
left or right.
 To stop the portable fan, place the switch in the center,
or OFF ( O ) position.
WARNING:
Hybrid tools are always in operating condition. Therefore,
switch should always be in the center, or OFF ( O )
position, when not in use.
CHANGING PORTABLE FAN SPEED
See Figure 4, page 10.
 For low speed, move the power switch to the LOW
( I ) position.
 For high speed, depress the power switch to the
HIGH ( I I ) position.
TO HANG THE PORTABLE FAN
See Figure 5, page 11.
Using the J Hook to hang the fan:
 Lift the J hook from the slot.
 Use the J hook to hang the portable fan. You may use
a screw to secure the fan in place. Do not overtighten.
NOTE: Be careful not to hang the fan in such a way that
it prevents normal fan operation or damages the cord.
8 – English