Publicité
Les langues disponibles
Les langues disponibles
SPEX WONDERSEAT USER MANUAL
Adjusting Back
Support Height
•
10mm Spanner
1.
Loosen the centre bolt and four outer nuts
to adjust the height.
2.
Add foam cubes or strips inside the cover
to match the back support height.
Installing Back Support
Upholstery & Trunk
Harness
•
No tools required
1.
Install the cover so that the back support shell
is inside the flaps.
2.
Pull the flaps over the top buckles
3.
Push the harness straps through all four buckles.
4.
Change the strap length then close the buckle levers
to lock the harness in position.
5.
Tuck the cover strap into the tab at the bottom
of the shell.
Tip: Harness width can be adjusted by moving
the buckles to different mounting points
using a 3mm Allen key, and an 8mm spanner
WARNING: Check that the top straps and buckles
are under the flaps as shown.
8
SPEXSEATING.COM
05
Publicité
