SPEX Wonderseat Guide D'installation Et D'utilisation page 12

SPEX WONDERSEAT USER MANUAL
Contouring the Back Support Surface
(Wonderseat Space Only)
The Classic Back Support has been designed to accommodate postural asymmetries and adapt to different
shapes. This guide shows how the inner section of the Classic Back Support can be changed.
Each cube compartment contains 2 cubes. These may be removed or added to as required. Each compartment
can have up to 3 layers of cubes. Keep any unused cubes as these can be used at a later date if the client's needs
change. The cubes must always face the rear of the Back Support.
Back/spinal protrusions
Open the zipper on the Back Support to release the inner contouring section. Remove this from the cover. You can
now remove layers of contouring cubes from where back protrusions need to recess into the Back Support. There
is sufficient padding behind the user if all of the compartment's cubes are removed to accommodate a prominence.
Back/spinal indentations
Open the zipper on the Back Support to release the inner contouring inner section. Remove this from the cover. You
can now add layers of contouring cubes where back indentations need more contouring support.
How to make changes with the user sitting in the wheelchair
Two people are required for this adjustment. Before doing this adjustment, retrieve a soft head pillow or similar
padded objects.
Lean the user forward to remove the inner contouring section of the Back Support (the cover will remain secured
to the Back Support shell) and replace with pillow.
Lean the user back.
Now the contouring section can be changed to suit the user's posture. Once finished, remove the pillow
and re-insert the inner contouring section.
Warning
Ensure the user has the hip belt fastened.
Warning
The second person must remain with the wheelchair
user to support them and keep them safe from falling.
12 SPEXSEATING.COM
05