Publicité
Les langues disponibles
Les langues disponibles
10.7 optional glass media installation
WARNING
!
•
Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
•
Do not change or substitute the glass media material provided with this appliance. If replacing, use only the
replacement glass media available from your local authorized dealer / distributor.
•
Glass media over the burner must not be more than one layer high. More than one layer over the burner will
cause fl ame lifting and sooting problems.
•
Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Evenly spread the glass media onto the media tray, covering the burner tube and tray. Ensure no glass
media falls into the pilot opening. If this happens, insert a clean bag into your vacuum cleaner and vacuum
out the glass media. Replacement glass can be purchased from your local dealer / distributor.
note:
Do not use more media than what was certifi ed with the appliance.
Cleaning Glass Media
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with
mild dish soap, drain, rinse thoroughly and dry before placing over the burner.
note:
Care must be taken to ensure glass media are kept clear of the pilot area on the media tray and are not
interfering with the pilot operation.
Pilot area
Glass media must be kept clear of
the rear slots of the media tray.
(sand
finishing
46.2A
W415-4077 / B / 01.31.23
EN
51
Publicité
