Makita XBU02 Manuel D'instruction page 95

Operation with abrasive cut-off /
diamond wheel (optional accessory)
1
2
3
010855
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle. Mount the
inner flange and abrasive cut-off / diamond wheel onto
the spindle. Tighten the lock nut securely with supplied
wrench. The direction for mounting the lock nut and the
inner flange varies by wheel thickness.
Refer to the table below.
115 mm (4-1/2") / 125 mm (5")
Abrasive cut-off wheel
Thickness: Less than
4 mm (5/32")
22.23 mm (7/8")
1. Lock nut
013349
WARNING:
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
NEVER use cut-off wheel for side grinding.
•
Do not "jam" the wheel or apply excessive
•
pressure. Do not attempt to make an excessive
depth of cut. Overstressing the wheel increases
the loading and susceptibility to twisting or binding
of the wheel in the cut and the possibility of
kickback, wheel breakage and overheating of the
motor may occur.
1. Lock nut
2. Abrasive cut-off
wheel/diamond
wheel
3. Inner flange
4
4. Wheel guard for
abrasive cut-off
wheel/diamond
wheel
Thickness: 4 mm (5/32")
or more
1
2
22.23 mm (7/8")
3
2. Abrasive cut-off wheel
Diamond wheel
Thickness: Less than
4 mm (5/32")
22.23 mm (7/8")
3. Inner flange
Do not start the cutting operation in the workpiece.
•
Let the wheel reach full speed and carefully enter
into the cut moving the tool forward over the
workpiece surface. The wheel may bind, walk up
or kickback if the power tool is started in the
workpiece.
During cutting operations, never change the angle
•
of the wheel. Placing side pressure on the cut-off
wheel (as in grinding) will cause the wheel to crack
and break, causing serious personal injury.
A diamond wheel shall be operated perpendicular
•
to the material being cut.
11
Thickness: 4 mm (5/32")
or more
1
4
22.23 mm (7/8")
3
4. Diamond wheel