Intended Use; Improper Use - Denios SpillGuard Guide Rapide

i
INFORMATION
SpillGuard® must be positioned so that
process-related electrostatic charges are
ruled out (e.g. from cleaning work, see also
TRGS 727 Sections 4 and 5).

2.2. Intended use

SpillGuard® is a mains-power-independent
leak recognition system for detecting leaks of
liquids / liquid hazardous substances.
It is designed for use in clean,uncontami-
nated spill sumps. The spill sumps should
preferably be in metal or non-metallic (plastic)
materials. Outdoor use is not permitted.
SpillGuard® may only be used within the limits
for use defi ned on the nameplate. It is
suitable for Ex zone 1, due to gases and
vapours.
SpillGuard® may only be used as a precaution
with the liquids which have already been
positively tested by DENIOS. The list of
positively tested substances can be found
here:
www.denios.com/spillguard
14/40
SpillGuard® Quick Guide | 269803 | Rev. 0
Hazardous substances which are not listed
here may not be used.
i
INFORMATION
If required, DENIOS can test a substance
which has not yet been tested to check the
safe operation and suitability of SpillGuard®.

2.3. Improper use

The device may not be used for the
following purposes:
Use in spill sumps for storing
W
non-approved media
Use in potentially explosive areas outside
W
the nameplate limits
Use in potentially explosive areas caused
W
by dust
Any use which is not expressly described
W
as permitted in this Quick Guide