Redfox FE 90/40 17 G Notice D'installation Et D'emploi page 9

CHECK THE GAS TYPE THE DEVICE IS ADJUSTED FOR
Our appliances are certifi ed and regulated the natural gas (see technical plate). Conversion or adaptation to
a different type of gas must be performed by authorized personnel. Nozzles for different types of gas are in a
bag provided with the gas cooker and are marked in hundredths of mm (table of technical data pipes).
Nozzle replacement and pressure adjustment
Proceed as follows when replacing the main burner nozzle:
1) open the door of the cabinet
2) acording to picture (2) unscrew the nozzle from the main burner and replace with nozzles according to
table „TECHNICAL DATA"
Proceed as follows when replacing the pilot burner nozzle:
1) Disassemble the front panel (pic. 3)
2) Disassemble cuprum pipe from the nozzle holder (pic. 4, fi g. B)
3) Disassemble the nozzle and replace as required (pic. 4, fi g. C)
4) According to picture (pic. 4, fi g. D) unscrew the nozzle from burner and replace with nozzles according to
table „TECHNICAL DATA"
Important:
After what was done adjusting the appliance to another type of gas, it is necessary to change the gas
indicated on the technical plate located in a visible location on the back of the device.
1
3
2
4
C
B
9