Redfox FE 90/40 17 G Notice D'installation Et D'emploi page 10

INSTRUCTION FOR USE
Attention!
Before the fi rst use of the device you must remove protection foil from all surfaces and wash the device with
water with detergent. Than splash it with clean water. Use the device under supervision. Never use the device
without oil or if the level of the oil is lower then min. line - danger of fi re. If the oil is dirty or you use the oil
longer time it may cause boiling over.
• Ignition of the main burner and regulation of the temperature: pictures 2
Turn the regulation knob (A) into position „ignition of the main burner" and then press it down and hold it.
Press down the piezo knob of the ignitor several times (B) until the main burner burns. The fl ame is visible
through the slot in the front panel (C). After ignition of the burner hold the knob (A) pressed several seconds
till the thermofuse gets hot. Then release the button. If the fl ame goes out repeat the whole process once
more.
• How to switch the whole device off: picture 2
Turn the knob (A) into position"0".
Comments and recommendation
You must always check the level of oil, never use the device without oil. Use the device only under supervision.
B
C
obr. 2
10
A
Regulation knob
A
Piezo knob
B
Slot for check the fl ame
C