Spark Plug Service - LONCIN 1P61FA Manuel D'utilisation

AIR CLEANER
BODY
INSPECTION
1. Press the latch tabs on the air cleaner cover or remove the cap nuts, and remove the
cover .check the filter to be sure it is clean and in good condition.
2. Reinstall the filter and air cleaner cover.
Cleaning
1. Tap the filter several times on a hard surface to remove dirt, or blow compressed air(not
exceeding 30 psi [207kPa, 2.1kg/cm
engine. Never try to brush off dirt. Brushing will force dirt into the fibers.
2. Tap the filter outer several times on a hard surface to remove dirt Clean. If the filter outer
is very dirty, replace the filter outer.
3. Wipe dirt from the air cleaner body and cover using a moist rag. Be careful to prevent dirt
from entering the air duct that leads to the carburetor.
CAUTION:
Operating the engine without an air filter, or with a damaged air filter, will allow
dirt to enter the engine, causing rapid engine wear. This type of damage is not covered by the
Distributor's Limited Warranty.

SPARK PLUG SERVICE

Recommended spark plugs: F7RTC or other equivalents.
CAUTION:
An incorrect spark plug can cause engine damage.
8. Disconnect the spark plug cap, and remove any dirt from
around the spark plug area.
9. Remove the spark plug with a spark plug wrench.
10. Inspect the spark plug. Replace it if the electrodes are worn, or
if the insulator is cracked or chipped.
11. if the insulator is cracked or chipped.
FILTER
FILTER, OUTER
²
])through the filter from the clean side that faces the
13
MAINTENANCE
AIR CLEANER
LATCH TABS
COVER
0.028-0.031 in
(0.70-0.80 mm)
GB