Starting Engine; Control Lever; Start Engine; Stopping Engine - LONCIN 1P61FA Manuel D'utilisation

3.5 STARTING ENGINE

3.3.1 Control Lever

 FOR STARTING A COLD ENGINE: Move the Control
Lever to the choke position.
 FOR RESTARTING A WARM ENGINE: Do not use the
choke when the engine is warm. Move the control Level
slightly past the idle position.
 FLYWHEEL BRAKE MODELS: Move the flywheel brake
lever (located on equipment) to release the flywheel
brake.

3.3.2 Start Engine


Grasp rope handle. Pull slowly until resistance is felt, then pull rapidly to start engine and
avoid kickback.
 If the choke was used to start the engine, move the throttle to the fast (or high) position as
soon as the engine warms up enough to run smoothly without use of the choke.
 FLYWHEEL BRAKE MODELS: Continue to hold the flywheel brake lever (located on
equipment). The engine will stop if you release the flywheel brake lever.
 Position the control Level for the desired engine speed. For best engine performance, it is
recommended the engine be operated with the throttle in the FAST (or high) position.

If using air pump carburetor，because there is no
throttle rod, so press AIR PUMP one time to 3
times according to the direction of the arrow when
cold start, then start it.
CAUTION
: Carefully check if there is
enough oil before starting.
DANGER
: Rapid retraction of starter cord
(kickback) will pull hand and arm toward engine
faster than you can let go.
Rotating parts can contact or entangle hands, feet,
hair, clothing, or accessories.
Running engines produce heat. Engine parts,
especially muffler, become extremely hot.
Severe thermal burns can occur on contact.

3.6 STOPPING ENGINE

5. Move the Control Level to the slow (IDLE) position.
6. Move the Control Level to the stop position.
7. FLYWHEEL BRAKE MODELS: Release the flywheel brake lever (located on equipment) to
stop the engine.
8. Turn the fuel valve to the OFF position if you do not intend to restart the engine soon.
STOP
AIR PUMP
9
CONTROLS
IDLE FAST CHOKE
AIR CLEANER
GB