Publicité
Les langues disponibles
Les langues disponibles
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of
a leak caused by damage to the cooler elements, move your fridge from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.
CLEANING AND MAINTENANCE
CLEANING
Do not use abrasive cleaning agents or solvents.
1.
Turn the appliance off. Disconnect the mains plug from the mains socket.
2.
Take out the food and store in a cool location.
3.
Clean the appliance with a soft cloth, warm water and detergent.
4.
Wipe the door seal with clear water only and then wipe dry thoroughly.
5.
After cleaning reconnect and adjust the temperature control knob as desired.
6.
Put the food back into the appliance.
DEFROSTING
A layer of frost in the freezer will impair refrigeration of the frozen food and increases power
consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or
pointed object. Doing this may damage the refrigerant tubes.
1.
Remove the frozen food and place temporarily in a cool location.
2.
Disconnect the appliance from the mains socket. Open the drainage opening and place a
bucket under it to catch the melted water.
3.
To accelerate the defrosting process, place a pan of hot water on a stand in the freezer.
4.
Wipe up condensation with a cloth or sponge.
5.
Wipe dry the freezer compartment. Close the drainage opening again.
6.
Plug in the appliance and adjust the temperature control knob as desired.
7.
Put the frozen food back in the freezer.
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble
shooting guide for a possible solution.
Does not work
· Check connection of power cord to power source.
· Plug in unit
· Use proper voltage.
36
DO936DVK
Publicité
