Far Group Startools GG 950 Mode D'emploi page 27

DANGER: Never connect the generator set earthing wire to piping. In addition,
the piping is carrying flammable substances such as gas or fuel oil, there is
always a risk of a fire or explosion in the event of a short-circuit
RECEIPT AND HANDLING
On receipt of your generator set, check that the equipment is in good condition and that
your order is complete. The generator should be handled with care and no sudden move-
ments, after preparing the area for its storage or use in advanc
Never try to start the generator before carrying out the preparation as described
in the precedent section of the manual.
EARTHING :
Earth the generator set each time it is used to prevent electrocution. For this purpose, use
a 10 mm2 copper wire attached to the generator's earth connector and a galvanised steel
earth rod inserted 1 metre into the ground (equipment not supplied with generator set).
This earthing also dissipates the static electricity generated by electrical machinery.
818015-Manuel-A 27
:
© FAR GROUP EUROPE
.
.
e
.
24/06/08 10:17:52
EN