RIB TOUCH Wi-Fi 2.0 Mode D'emploi page 19

IN CASES OF DIFFICULTY
The strip does not work
FOR OTHER INFORMATION REFER TO THE INSTRUCTION BOOKLET OF THE MASTER Wi-Fi CARD
ELECTRONIC TECHNICAL CHARACTERISTICS
FREQUENCY
SENSITIVITY
OUTPUT POWER
POWER SUPPLY
INPUT AT REST
MAXIMUM INPUT
MODULATION TYPE
CAPACITY
BATTERY LIFE
CAPACITY OF CONTACTS
WORKING TEMPERATURE
DEGREE OF PROTECTION
DEGREE OF RELATIVE HUMIDITY
TECHNICAL MECHANICAL CHARACTERISTICS
STROKE FROM CONTACT TO INTERVENTION (PRE-STROKE)
STROKE FROM INTERVENTION TO MECHANICAL STRIKER PLATE (BEYOND STROKE)
OPENING TIME OF CONTACTS AFTER INTERVENTION
RECOVERY TIME OF MAXIMUM DEFORMATION
MAXIMUM FORCE APPLICABLE TO THE DEVICE
MAXIMUM SPEED OF DEVICE IN MOTION
*
Using with operators at a speed greater than 0.25 m/s (15 m/min) is a breach of regulatory provisions.
ACCESSORIES
AA LITHIO BATTERY
PROBLEM
868,3 MHz
-108 dBm
<25 mW
type AA battery 3,6 V (> 2,6 mAh)
25 µA
13 mA
FSK
20 m in free space without antenna
3 years
0,5 A - 24 V c.a. c.c.
-20°C ÷ +60°C
IP44
<93%
max 15 mm
min. 40 mm
max 0,1 s
max 0,5 S
max 1 KN
max 0,25 M/S *
code ACG9517
Check condition of batteries and contact
ROUTINE MAINTENANCE
Must be carried out every six months, only by authorized personnel in agreement with the
safety rules and with the manufacturer's instructions.
- The TOUCH Wi-Fi safety edge must be kept in efficient working conditions and in agreement
with the manufacturer's instructions.
- Replace the batteries when requested by the system (see the chart "IN CASE OF DIFFICULTIES"
on the MASTER Wi-Fi manual).
- Verify the presence and the possibility to read the initial marking.
- The parts that wear off are mentioned in the chart "Type of items for the assembly"; eventual
replacements must be carried out by an authorized technician, following the assembly
instructions and verification.
1 - Make sure covers (upper and lower ) and aluminum support are in good condition and not
bent out of shape; make sure rubber part is in good condition and not torn.
2 - Dismantle cover.
3 - Check steel cable to make sure it is in good condition and not frayed; replace cable is
necessary.
4 - Make sure that in conditions of rest, the lever is positioned on the central limit switch. If it
is not, regulate the position by turning the adjustment screws.
5 - Check condition of upper cover and replace it if it is damaged.
6 - Make sure there are no traces of moisture or foreign bodies and remove them if there are
any.
7 - Keeping the contact of the central limit switch pressed, press the rubber and make sure
the electric circuit is interrupted.
8 - Release rubber strip and make sure electric contact resets.
9 - Put cover back on.
19
CHECK
G
B