Würth 0691 850 3 Traduction Des Instructions De Service D'origine page 7

Start-up
The product should be serviced in accordance with
maintenance instructions.
Operation
Risk of severe injuries.
Only use designated lifting points
¾
Lift at the centre of gravity, not on the
¾
side or at an angle.
The jack and support frame must not
¾
be used simultaneously on an end
of the vehicle or on a side of the
vehicle.
1. Only use the designated lifting points on the ve-
hicle. Refer to the user manual of the vehicle to
identify the lifting points.
2. Place the support frame at the designated lifting
points.
3. For aligning the support frame: Keep the control
lever up while you lift the saddle shaft [2] to the
desired height. Press the control lever [3] down
in order to lock the pawl [4] into the teeth in the
centre column [5]. Ensure that the pawl
completely engages into the teeth.
4. Carefully lower the vehicle onto the support
frame slowly.
Maintenance and cleaning
▸
Prior to use, carry out a visual check for cracks,
damaged weld seams, bending, loose and mis-
sing parts or leakage.
WARNING!
Disposal
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste disposal
company or via your local authority
waste disposal facility. Observe the
currently valid regulations. In case of doubt, contact
your waste disposal facility. Dispose of all
packaging in an environmentally compatible
manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with
the legal/country-specific regulations (proof of
purchase through invoice or delivery note). Damage
that has occurred will be corrected either by repla-
cement or by repair. Damage caused by improper
handling is not covered by the warranty. Claims
under warranty can only be accepted if the device
is returned fully assembled to a Würth agency, your
Würth sales representative or an authorised Würth
customer service workshop. Subject to technical
changes without prior notice. We accept no liability
for printing errors.
7