Publicité
Operation
needle and a conical adapter are in the clamps on top of the compres-
sor pump. The ball needle is stored inside the conical adapter.
The Worklight
The worklight and the display illumination turn on when an operating
element is used.
Both turn off about 10 minutes after the last operation with the pump.
The Trigger Switch
To turn on the compressor pump and press the trigger switch (4). To
turn off the compressor pump press the trigger switch again.
Operating the Compressor Pump
WARNING: Do not operate the Compressor Pump for more than 10
minutes continuously. After operation allow it to cool down for 15
minutes.
Setting the desired pressure:
Use the pressure hose and, if needed, and adapter to connect the
compressor pump to the valve of the item to be inflated.
Press a button to activate the display. Press the Button (9) multiple
times o select the desired unit of pressure and then set the pressure
with the + and – buttons. After a few seconds the display will switch to
the current pressure.
When the trigger switch is now operated the object will be filled with the
set pressure.
Service
WARNING: Always disconnect from the mains power supply, before
carrying out any maintenance/ cleaning of the charger. Remove the
battery before carrying out any maintenance/cleaning of the tool.
Note: Both the tool and the charger contain no user-serviceable parts.
If the device does not perform as outlined in this manual, turn to the
Westfalia customer service or to a competent professional.
15
Publicité
