Beamz Magic 1 Mode D'emploi page 6

Press the red button to turn the device on, press again to turn in standby mode.
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode, press
To change the colour of the strobe, press
To put the UV light on press
To turn on Sound-Active mode, press
No function.
To change the strobe with LEDs, press
To change the derby effect.
1. Press on the remote controller.
2. Press or to change effect.
To change the speed of colour change, colour fade, sound active and strobe modes.
1. Press on the remote controller.
2. Press or to increase or decrease the speed of colour change.
To adjust sound sensitivity for in Sound-Active mode
1. Press on the remote controller.
2. Press or to either increase or decrease sound sensitivity(note: only available in sound active mode).
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
on the remote controller.
.
, to put the UV light off press
on the remote controller.
.
once again.