Power Adhesives 308B-12 Mode D'emploi page 3

SAFETY INSTRUCTIONS
EN
Do not touch the nozzle or molten adhesive
with bare skin as they are hot - the operating
temperature of this tool is approximately
200°C / 392°F HOTMELT (165°C / 329°F
ECO). Protective gloves should always be
worn. Careless handling can cause skin
burns. If molten adhesive comes into contact
with the skin, immerse the affected area
immediately in plenty of cold water. Seek
medical advice if necessary. In addition to
the safety instructions herein, any statutory
regulations, local fire insurance regulations,
or other generally valid "regulations for
accident prevention" must be complied with
when using this tool.
Repairs should only be undertaken by
competent personnel with the adequate
electrical knowledge. Before proceeding
with any maintenance or repair operation,
disconnect the tool from the battery. If in
doubt, contact your supplier.
• WARNING - Do not leave the tool unattended
when switched ON.
• Never use the tool if it or the battery is
damaged in any way.
• Do not use this tool whilst under the influence
of drugs or alcohol.
• Do not use this tool in damp rooms, and do
not expose to rain, moisture or immerse in
water.
• Do not use this tool in the vicinity of any
heat-sensitive materials, or any flammable
materials, liquids, or gases, and do not apply
to the same place for a long time.
• Turn off the tool when attaching and
disconnecting the battery pack.
• Do not place battery packs near a fire or
other heat source, nor incinerate or dispose
of batteries in a fire, as they could explode.
• When not connected to the tool, protect the
battery's contacts from short-circuits, and
place electrical tape over the contacts before
disposal/recycling.
• This tool can be used by children 8 years
and above as well as persons with reduced
physical, sensory or mental capabilities, or
lack of experience or knowledge, only if they
have been given supervision or instruction
concerning the safe use of the appliance and
understand the resulting dangers.
• Children are not allowed to play with the
appliance. Cleaning and user maintenance
must not be performed by children without
supervision.
AVOIDING PROBLEMS
• Ensure that tool has reached temperature before
operating.
• Do not leave tool switched on for long periods without
useIf tool is not to be used for more than 40 minutes,
switch off and restart when required.
• Never lay the tool on its side. Always stand tool upright
or the optional suspension unit.
• Only use adhesives designed for use with this tool.
• Never remove a partially used glue stick. This can lead
to irreparable damage.
• Hotmelt glue can be used instead of nails, staples,
tapes, and liquid glues. However they should not be used
in place of structural connections when heavy loads are
involved.
• Do not use hotmelt glue for objects that are exposed to
extreme heat. Some glues that can be used in this tool
will soften at 60°C (140°F).