Cleaning And Storage - MAXXMEE HC20Pro-7B Mode D'emploi

LED Power Control Cordless Cyclone Vacuum Cleaner
after use (see the "Charging Up the
Battery" chapter).
1. Select an accessory as required (see
the "Accessories" chapter) and attach
it to the device (see the "Assembly"
chapter).
2. Switch on the device by pressing the
On / Off switch (7) once. The device
will start vacuuming immediately. The
touch display (6) lights up.
3. If necessary, the suction strength can
be changed manually via the touch
display by touching the fi eld
. If the AUTO symbol is touched,
the intelligent suction strength control
can also be set (see the "Touch
Display" chapter).
4. Move the device over the surface to
be cleaned.
5. To switch the device off again, press
the On / Off switch again.

CLEANING AND STORAGE

Please Note!
■
Do not immerse the EPA fi lter in
water or rinse it under running water
to prevent damage to the fi lter. It is
neither machine-washable, dishwasher-
safe nor suitable for tumble drying.
■
The dust fi lter is neither machine-
washable, dishwasher-safe nor suitable
for tumble drying! Only ever dry it in the
air, and never use a hair dryer to do so.
■
Do not use any sharp or abrasive
cleaning agents to clean the housing.
They may damage the surfaces.
 
The EPA fi lter may lose some of
its colour over time. This is normal
and does not have any adverse
effect on function.
Emptying the Dust Container
1. Take the dust container (3) off the
motor unit (E) (see the "Assembly"
chapter – "Removing / Inserting the
Dust Container").
2. Hold the dust container over an
open dustbin. The distance from the
dustbin should be as small as possible
so that the dust does not spread in
the surrounding air.
3. Press the tab (2) on the dust container.
The lid of the dust container (1) will
open and the dirt will fall out.
4. To close it, press the lid onto the
dust container. The tab must engage
audibly.
or
Cleaning the Dust Container, EPA
Filter and Dust Filter
1. Reach into the dust container (3) and
pull out the dust fi lter (4) with the EPA
fi lter.
2. Twist the dust fi lter anticlockwise and
pull the EPA fi lter upwards.
3. Tap out all parts and clean them with
a soft brush if necessary.
4. The dust fi lter can also be rinsed with
clear water. NOTICE: Do not wet-
clean the EPA fi lter!
5. Wipe out the dust container with a
damp cloth if necessary.
Allow all parts to dry completely in
the air before you reassemble them.
NOTICE: Never assemble wet or
damp components or attach them to
the motor unit (E)!
Assembly
1. Place the dust fi lter onto the EPA fi lter
in such a way that the locking lug fi ts
in the recess which is provided for it.
Twist the dust fi lter clockwise until it
fi ts securely.
2. Insert the dust container with EPA
fi lter into the dust container. The dust
fi lter must fi t correctly in the dust con-
tainer, it must not stick out at the top.
3. Insert the dust container back into
the motor unit (see the "Assembly"
EN
19