Toro 51955 Manuel De L'utilisateur page 15

Starting the Product
See Figures 6 - 8.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air filter cover.
To Start a Cold Engine:
Follow these steps to start a cold engine.
1. Lay the product on a flat, bare surface.
2. Push the primer bulb approximately eight times.
FULL
3. Set the choke lever to
4. Depress lock-out button and squeeze throttle trigger
fully (thru step 7) and pull starter handle sharply until
engine attempts to start (no more than 4x).
HALF
5. Set the choke lever to
6. Pull starter handle until engine runs, no more than 6
pulls.
RUN
7. Set the choke lever to
Note: In cooler environments, additional pulls of the
starter handle may be required with the choke lever in
FULL
the position.
To Start a Warm Engine:
Follow these steps to start a warm engine.
1. Lay the product on a flat, bare surface.
2. Push the primer bulb up to eight times.
RUN
3. Set the choke lever to
4. Depress lock-out button and squeeze throttle trigger
fully, pull the starter cord.
Note: If the product does not start, repeat the previous
steps.
On/Stop
Switch
Lock-out
Button
Throttle
Trigger
Operation
.
.
.
.
Primer
Starter
Bulb
Grip and
Rope
Figure 6
Set Choke to FULL
Stopping the Product
See Figure 8.
Follow these steps to stop the product.
1. Release the trigger.
2. Press on/stop switch to
Throttle
Trigger
Set Choke to RUN
Figure 7
(STOP)
position.
On/Stop
Switch
Figure 8
15