Hilti Nuron SID 4R-22 Notice D'utilisation Originale page 17

5.5 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift
the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
5.6 Turning tool holder
For better accessibility in tight spaces, you can set the tool holder to
different angles.
1. Slacken the screw at the tool holder.
2. Remove the tool holder and turn it to the desired angle.
3. Re-install the tool holder on the product.
Make sure that the recesses and the grooves are aligned.
4. Re-tighten the screw to secure the tool holder.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Selecting mode
▶ Repeatedly press the mode selector until the mode indicator shows the
speed stage you want to use.
*2373959*
3
4
2373959 English 13