Haussmann Xpert PNT142-R Mode D'emploi page 20

OPERATING PROCEDURES
2. Pull feeder shoe all the way to the rear, until it latches (Fig.4).
3. Line up a strip of nails with points down and drop into the magazine (Fig.5).
4. Slide the nails forward in the magazine. The magazine will hold 2 strips of 40 nails at
28 degrees.
5. Push the lock forward and allow the feeder shoe to slide forward against
nails (Fig.6).
USING THE TOOL
Complete all the steps in PREPARING THE TOOL before using. This tool drives nails
in sequential fire mode:
1. Put the contact tip (C, Fig.7) of the tool on the working surface.
2. Lightly push the tool toward the working surface until the safety bracket is
depressed.
3.
most accurate fastener placement.
CAUTION:


 Keep the tool pointed in a safe direction at all times.
 Never attempt to drive a fastener into material that is too hard, at too steep an
angle, or near the edge of the work piece. The fastener can ricochet causing
personal injury.
 Clean and inspect the tool daily.
 Carefully check for proper operation of the trigger and safety.
 Do not use the tool unless both the trigger and the safety mechanism are
functional, or if the tool is leaking air or needs any other repair.
20
PNT142-R
Fig.4
Fig.5
Fig.6
B
A
C
Fig.7
!