6.
OPERATING INSTRUCTIONS
6.1 Direct the lens away from your eyes before turning on the work light.
6.2 Press
once to turn on the light.
6.3 Press
off and on again to toggle between 100% and 50% power.
6.4 While light is on, turn the barrel to focus the beam.
6.5 Press
once, to turn off the light.
6.6 Recharge the work light after use, and at least every 6 months.
7.
MAINTENANCE INSTRUCTIONS
7.1 Before performing maintenance, disconnect the work light from your charger.
7.2 Use a dry cloth to wipe any dirt or oil from the charging cable and case.
7.3 Any servicing should be performed by qualified service personnel.
8.
STORAGE INSTRUCTIONS
8.1 Store inside, in a cool, dry place.
8.2 Take care to avoid/prevent damage to the charging cable and unit. Failure to do
so could result in personal injury or property damage.
8.3 Charge the work light's internal battery immediately after purchase, after every
use and every 6 months.
8.4 All batteries are affected by temperature. The ideal storage temperature is at
70°F. The internal battery will gradually self-discharge (lose power) over time,
especially in warm environments. Leaving the battery in a discharged state may
result in permanent battery damage. To ensure satisfactory performance and
avoid permanent damage, charge the internal battery every 6 months.
9.
TROUBLESHOOTING
PROBLEM
The work light does
not operate.
POSSIBLE CAUSE
The battery is not charged.
The battery may be bad.
Recharge the battery to full
charge.
Have the battery replaced
by a qualified service
technician.
• 7 •
VOTING
SOLUTION