Maintenance And Care; Switching Off The Electricity; Cleaning The Filter After Each Cycle; Check The Drum After Each Cycle - Indesit ISL60V Manuel D'installation

Maintenance and Care

Switching off the electricity

Unplug your dryer when not using it, when cleaning it
and during all maintenance operations.
Clean the filter after each cycle
The filter is an important part of your dryer:
it accumulates lint and fluff that is formed while drying.
Small items could also become trapped in the filter.
When finished drying, therefore, clean the filter by
rinsing it under running water or with your vacuum
cleaner. Should the filter become clogged up, the
airflow inside the dryer will be seriously compromised:
drying times lengthen and you will consume more
energy. It may also damage your dryer.
! Do not use the dryer without replacing the filter.

Check the drum after each cycle

Turn the drum manually in order to remove small
items (handkerchiefs) that could have been left
behind.
The filter is found in front
of the dryer trim
(see diagram).
Removing the filter:
1. Pull the plastic grip of
the filter upwards (see
diagram).
2. Clean the filter and
replace it correctly.
Ensure the filter is fully
located flush into the
tumble dryer trim.
Cleaning
External parts in metal or plastic and rubber parts
can be cleaned with a damp cloth.
Periodically check the vent tube and any
permanent venting fixture to make sure that there
has been no accumulation of fluff or lint, and
remove it.
Periodically clean the surface of the stainless
steel sensor inside the drum with vinegar to
remove water contaminates. Apply carefully with
a cloth, this will maintain the drying performance
of the dryer. The sensor is located on the plastic
vane inside the drum towards the front of the
dryer. Rotate the drum if necessary to locate it.
Remove lint that collects around the filter and the
outlet vents.
! Do not use solvents or abrasives.
! Your dryer uses special bearing components which
do not need lubrication.
! Have your dryer checked regularly by authorised
technicians to ensure electrical and mechanical safe-
ty (see Service).
GB
11