Publicité
Les langues disponibles
Les langues disponibles
PRX-3A
Power for Receiver
General technical characteristics
- The PRX is based on a linear regulator, as - unlike switch-mode regulators - this form of
circuit generates no unnecessary interference to the receiving system.
- The in-line layout of the switch, LED and mounting holes makes the unit simple to install
in your model, and looks visually attractive.
- A set of adapter leads is supplied in the set. Batteries fitted with the following connector
contacts can therefore be used without any soldering:
GRAUPNER|JR
G2
G3,5
BEC
- If the input voltage is above 9 V, the unit generates an error code to protect the circuit;
if this should occur, the output is switched off after one second.
- An input voltage above 12 V may permanently damage the PRX.
- Battery types:
- Input voltage:
- Max. input voltage:
- Idle current:
- Max. continuous current:
- Max. peak current:
- Max. peak current:
These figures are valid when the PRX is used without active cooling, such as a forced
airflow. With effective cooling the values are even higher.
- Weight:
Two-cell LiPo
Two-cell LiFe
Two-cell LiIon
Five-cell NiMH / NiCd
Six-cell NiMH / NiCd
(below 4V: stable operation impossible)
(below 4V: stable operation impossible)
4V to 9V
4V to 9V
4V to 9V
12V
approx. 0.3µA
(switched off)
(switched off)
0.3µA
0.3µA
approx. 3A
(for 1 MIN. with LiPo, 5.9 V output)
approx. 10A
(for 1 SEC. with LiPo, 5.9 V output)
approx. 20A
(for 100 MSEC. with LiPo, 5.9 V output)
approx. 31g
13
Publicité
